Ericsson EDACS Station GETC1e 19D901868G4 Instrukcja Instalacji Pobierz pdf (Strona 19)

CONFIGURATION LBI-38987B

PERSONALITY PROGRAMMING

Personality refers to the system configuration data

stored in the GETC's memory. The GETC's Personality

includes system configuration information such as channel

frequencies, call parameters, operating modes, and

identification information.

The Personality Programming process involves using

the TQ-3357 GETC Shelf PC Programmer which includes

the programming software to create the desired personality

and transfer the Personality data to the battery backed-up

RAM located on the Turbo Board.

If installing GETC software 349A9607G5 (or

later), PC Programmer TQ-3357 V5.0 or V4.03

with Field Macro file “

gtc_9505.mac

” is required

to access 349A9607G5 features’ parameters.

The TQ-3357 V4.03 (or later) also allows you to upload

the GETC’s Personality without changing the DIP switch

settings.

NOTE

It is not necessary to recreate the personality when

upgrading from 344A3835G2 software to

349A9607G5 except when upgrading non-turbo

platforms.

To activate new features, read the existing

personality and edit the personality as required.

Programming a Personality Using TQ-3357 V3

(or earlier)

When using TQ-3357 Version 3 (or earlier) you must

program the personality through J100.

1. Connect one end of the serial programming cable (TQ-

3360) to the computer. Connect the other end of the

serial cable to the GETC Shelf connector J100, see

Figure 7.

2. Set the GETC DIP switches S1, S2, and S3 for the

programming mode as shown in Figure 8. Set S2-8, S3-

3 and S3-6 to OPEN. All other S3 positions should be

CLOSED. Switches S1-1 thru S2-7 can be in any

position and need not be changed. DIP switches S1-S3

are located near the front of the GETC Shelf, see Figure

3. Reset the GETC by either applying power or pressing

the GETC RESET switch S4, see Figure 6, located just

below the DIP switches. Resetting the GETC, in

combination with the DIP switch settings, places the

S3S2S1

L1 L2 L3 L4 L5 L6 L7

T1 T2

U18R1

U19

J49

J27

J10

J9 J8 J5

J19

TP107

Software Disk

TQ-3357 V3 or earlier

COM 1 or

J100

Harness 19C336863G2

TQ-3360

TQ3357

GETC Shelf 19D901868G3

Cable

U19

J49

TP107

Turbo Board Lightning GETC

COM 2

Dip Switches S1-S3

Switch S4

Figure 7 - System Hook-Up Using J100

NOTE

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Komentarze do niniejszej Instrukcji

Brak uwag

Ericsson EDACS Station GETC1e 19D901868G4 Instrukcja Instalacji Strona 19

Komentarze do niniejszej Instrukcji