Ericsson LBI-39001 Instrukcja Użytkownika Pobierz pdf (Strona 12)

LBI-39040 INITIAL SETUP

12

Table 2 - CONFIG.DAT File Loading

Type of Loading Procedure Expected Results

Jessica loading of

configuration data

from the floppy disk

drive.

(Files are edited on a

separate host.)

1. Copy the CONFIG.E1 or CONFIG.T1 file

on Jessica Disk 4 to CONFIG.DAT on the

same disk. Choose the appropriate file

based upon Jessica being E1 or T1.

2. Edit the CONFIG.DAT file on Jessica Disk

4 to match your application. This is the

minimal set to place a call.

• SITE_ID range 1-32. Must match PIM

Controller site ID. Default is 16.

• HANG_TIME range 0-255 seconds. Set to

a value equal to the System Manager

Interconnect Hang Time and the GETC

Special Call Hang Time.

• CONVERSATION_LIMIT range 0-255

minutes. Must be set to a value higher

than the System Manager Message

Conversation Limit and the GETC Message

Trunked Timer.

• MUX_CHANNELS_MASK range 0X0 to

0XFFFFFFFF hex, with the MSB

corresponding to channel 32 and the LSB

corresponding to channel 1. Must match

the channels equipped in the MUX and

connected to PIM audio channels in the

CEC/IMC. Leading zeroes can be left out.

Example: 0XF enables MUX channels 1-4

for interconnect. T1 supports up to 23

channels, and E1 supports up to 30

channels.

• TRUNK_TYPE must be set to T1 or E1.

• Features -- See section 4.1 herein for

instructions on how to tailor CONFIG.DAT

to incorporate the features available in

Jessica.

3. Insert Jessica Disk 4 into the PI floppy drive

(4th disk after Table 1).

4. The PI terminal will indicate the copy of the

following files to the PI hard drive:

CONFIG.DAT (if renamed in Steps 1 and 2

above, otherwise have CONFIG.E1 and

CONFIG.T1), ALLOW.DAT,

DISALLOW.DAT, PRIORITY.DAT, IP.DAT,

ROUTES.DAT, PBXFEAT.DAT, and

EXPORTS.DAT

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 95 96

Komentarze do niniejszej Instrukcji

Brak uwag