Ericsson EDACS PRISM HP Instrukcja Operatora Pobierz pdf (Strona 43)

Press

a second time to set the group to Priority

2. A is displayed on line three.

Press

a third time to set the group to Priority 1.

A is displayed on line three. The priority level

selection sequence only advances the group to next

higher priority level and stops at priority level 1. To

select a lower priority level, the group must be de-

leted from the scan list and then added back to the

scan list. Each new group added to the scan list

starts at the lowest priority. If the Priority 1 and

Priority 2 groups are already set and a new group is

assigned as Priority 1 or Priority 2, the previously

assigned group will change to non-priority scanning.

One of the following messages may be momentarily

displayed:

SCAN DIS

The radio is not programmed to scan.

FIXED P1

A Priority 1 group has been pre-pro-

grammed into the radio. A new Priority 1

group cannot be selected.

FIXD LST

A fixed scan list has been pre-pro-

grammed into the radio. It is not possible

to change the list without reprogramming

the radio.

Note: To quickly view multiple group scan status,

press either

or the key. Then slowly but

consistently rotate the group knob. Each group

status will appear on the display.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 103 104

Brak uwag

Ericsson EDACS PRISM HP Instrukcja Operatora Strona 43